Application — Robot system power
Requirement — This robot system power application also required 24V·12V regulated auxiliary power.
Solution — We integrated 24V·12V regulated DC-DC converters into a Li-ion 7S pack (DC 25.2V, 122.4Ah).
Result — A discharge configuration rated at 50A maximum (100A peak @ ≤1.5s), housed in approx. 14kg, completes robot system power in a single pack.
If you are considering a custom build to a similar specification, submit a requirements sheet. Our engineer will review it and respond.
Specification
Specifications
| Product Code | DMOP-252LI1224-B100-CV12 |
|---|
General
| Model | DMOP-252LI1224-B100-CV12 |
|---|---|
| Dimension | Approx. L340 x W380 x H145mm (including protrusions) |
| Weight | Approx. 14kg |
Battery ① Electrical specifications
| Battery Type | 7S Li-Ion |
|---|---|
| Nominal Voltage | 25.2V (21.0–29.4V) |
| Nominal Capacity | 122.4Ah |
| Energy | 3,084Wh |
| Max Discharge Power | 1,260W |
| Charging Method | CC-CV(Constant Voltage with Limited Current) |
| Standard Charging Condition (0.2C) | 29.4V±1%, 24A, CC-CVEnd Current : 2.4A (0.02C) |
| Max Charging Condition | 29.4V±1%, 61A, CC-CVEnd Current : 2.4A (0.02C) |
| Standard Discharge Current (0.2C) | 24A |
| Max Discharge Current | 50A |
| Instantaneous Discharge Current | 100A @ ≤1.5s |
| Discharge Cut-off Voltage | 21.0V3.0V per cell |
| DC-DC Converter | DC12V regulated output (Max 20A) |
Battery ② Operation · Safety
| Max Temperature Range | Charging: 0 – +45°C Discharging: -20 – +55°C Storage (recommended): +5 – +30°C |
|---|---|
| Battery Management System | Module configuration: 3P Overcharge cutoff: 4.20–4.25V±25mV per cell Overcharge recovery: 4.00–4.20V±50mV per cell Over-discharge cutoff: 2.50–2.90V±80mV per cell Over-discharge recovery: 2.70–3.30V±100mV per cell Overcurrent cutoff: 135A–160A±25% per module Short-circuit protection: Yes Over-temperature cutoff: Yes Cell balancing: Yes Control method: MOSFET |
| Storage Life | Up to 6 months under no-load conditionsState of charge: SoC 60% Environment: ambient 25°C, humidity ≤70% |
| Cycle Life | ≥60% of nominal capacity after 500 cycles Charge/discharge condition: standard charge, then discharge at the standard discharge current down to the cut-off voltage |
Terminals · Control
| Terminal configuration | Positive(+) : 2P(++) Negative(-) : 2P(--) |
|---|---|
| Terminal specification | Rating: 600V, 100A (per pin) Operating temperature range: -40°C – +85°C |
| Terminal fastening and wiring | Bolt: SCREW M6X16 nut Thread: M6*P1.0(B5.0) |
| Charge/discharge switch (ON/OFF) | Option: charge/discharge rocker switch (ON/OFF) |